Monte Carlo Fan Company 3VNMR56 D-V1 Series, Руководство пользователя и инструкция по установке

Страница: 5 / 9

5
© 2015 Monte Carlo Fan Company
12/2017
13 14 15
16 17 18
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
Connect white wire from fan to white wire
from LED light kit and then connect blue
wire from fan to black wire from LED
light kit.
Attach LED light kit to light pan by
locating dimples in light pan with grooves
on the LED light kit and twist clockwise
until tight.
Note
:
If you don’t want to install the
fan with LED light, go to step 17 for
blanking plate installation.
Setting the reverse switch on the left
hand side will result in downward airflow
and setting the switch on the right hand
side will result in upward airflow.
Note : Reverse switch must be set either
way completely. If the reverse switch is
set in the middle position, fan will not
operate.
Remove LED module and Light shade
from Light plate as shown in illustration.
Keep screws.
Install blanking plate onto light plate using
the set screws of light shade which were
just removed.
Attach light pan onto the plate on motor,
aligning the keyhole slots on the light
plate with the preassembled screws on
the plate. Twist clockwise till lock.
Reinstall the screw removed in step 13.
Tighten all screws securely.
Plate on motor
Light pan
LED light kit
Reverse switch
Install LED Light Kit
LED Module
Light shade
Light plate
Install blanking plate
Blanking
plate
Light plate
Blanking plate assembly