Montana MSRGG4B, Руководство пользователя

Страница: 28 / 34

Warnings
Before proceeding, make certain that you have assembled the appliance according to instructions.
Use your Barbecue at least 100cm away from any wall or surface.
Never use your gas barbecue in a building, garage, shed, breezeway, or any other enclosed area.
Never obstruct the flow of ventilation air around your gas barbecue housing.
Before lighting
Inspect the gas supply hose prior to turning the gas “ON”. If there is evidence of cuts, wear or
abrasion, it must be replaced prior to use. Check leakage before use. Do not use the barbecue if the
odor of gas is present.
P
LIGHTING MAIN BURNERS & INFRARED
LIGHTING ROTISSERIE BURNER
LIGHTING SIDE BURNER
reparation before cooking
T
Always inspect gas supply hose prior to turning gas ‘‘ON’’. If there is evidence of cuts, wear or
abrasion, it must be replaced prior to use. Do not use side burner if the odour of gas is detected.
Keep face away when igniting.
1. Open side burner lid before lighting.
2. Push and turn counter clockwise the control knob for the side burner to ignition position, keep
pushing and press on electronic igniter button for 2 to 5 seconds.
If burner does not light after 5 seconds, turn controls to OFF “ ” and wait 5 minutes for any
accumulated gas vapours to dissipate.
If electronic igniter does not work, light manually asexplained on page 29.
1. Open lid before lighting.
2. Set ALL control knobs to OFF “ ” and SLOWLY open cylinder valve.
3. Push and turn either control knob anti-clockwise to approx 1/4 position. Continue pushing knob
while pressing the ignition button for 2 to 5 seconds. Burner should light up within 5 seconds.
If burner does not light after 5 seconds, turn control to OFF “ ” and wait 5 minutes for any
accumulated gas vapours to dissipate. Then repeat lighting procedure.
4. When burner is lit, release knob and turn to adjust heat setting.
1. Open lid before lighting
2. Push and turn counter clockwise the control knob for the rotisserie burner to ignition position,
keep pushing and press on electronic igniter button for 2 to 5 seconds.
3. Once burner is lit, keep pushing on control knob for about 30 seconds. Then release it, burner
should stay lit. Rotate knob to adjust heat setting.
If burner does not light, turn control to OFF “ ”. If electronic igniter does not work, light manually
as explained on page 29.
o prevent foods from sticking to the cooking grill, please use a long handled brush to apply a light
coat of cooking or vegetable oil before each barbecuing session. (Note: When cooking for the first
time, coating color may change slightly as a result, this is normal and should be expected.)
Operating instructions