MONTAGUE DIRECT CONNECT, Руководство пользователя

Страница: 33 / 56

33
INSTALLING RACKSTAND™
If your Montague bike comes with a
RackStand that is not installed, or you
are replacing it, the following instructions
can be used.
To Install RackStand:
1. Remove the original rear wheel
quick release by unscrewing the end
nut. Replace with RackStand quick
release with spacers in order shown
(Fig. 39). Tighten to proper tension
(page 44).
2. Place RackStand upside down
(stand position) on the floor, with tail
facing the front of the bike (Fig. 40).
3. Position the rear of the bike so it is
resting on the tabs of the new quick
release as shown. (Fig. 40).
4. Open the QR lever and lower bike
into the RackStand slots (Fig. 41).
5. Close quick release lever and rotate
RackStand up to the riding (rack)
position. Ensure it is locked into
mating latch (Fig. 42).
Fig. 39: Installing RackStand quick release.
Fig. 40: Positioning Rackstand (wheel not shown
for clarity).
Fig. 41: Lowering bike into Rackstand dropouts.
Fig. 42: Rotate RackStand and lock in place.