the MFB button on the left & right earphones. At this time, the white indicator light on the earphones
will flash 3 times quickly, indicating that the earphones have been restored to factory settings.
LED Indicator Guide
Mode
Description
Voice prompts
Power On
Indicator Light: white light stays on about 1
second
Power On
Power Off
Indicator Light: red light stays on about 1 second
Power Off
Pairing
Indicator Light: white light flashes
Pairing
Connected
Indicator Light: light goes off
Connected
Earphone charging
Indicator light: the red light is on when the
headset is charging
-
Charging case charging
Charging Case Indicator Light:
Red light is on during charging and off after fully
charged.
-
Note:
* After removing the earphones from the charging case, without pressing any buttons, the left
and right earpieces will connect automatically. If there is no connection found, it enters to
pairing mode automatically.
* Please put the earphones in the correct position to charge.
* Do not replace the battery at unapproved repair technician.
* The battery (battery pack or combination battery) must not be exposed to excessive heat such
as sunlight or fire.
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
RF warning statement:
