MTWTDB-V1-040105
Pg
3 of 3
Copyright 2002-2005, Monster Tower, Inc.
Assembly Instructions
STEP 1: Attach the Collar Bracket (Item 1) to the tower using M8x25 tower clamp bolts (Item 3)
and the Delrin Collar Inserts (Item 2) that matches your size tower (2-1/2” are provided for Monster
Towers and a universal kit with 1-1/2”, 1-5/8”, 1-3/4”, 1-7/8”, 2” and 2-1/4” are provided for other
towers). Tighten to 20 ft-lbs.
STEP 2: Loosen the Item 4 Mounting Post Bolts and rotate the Item 1 Mounting Post so the hole
in the post aligns with the centerline of the boat. Tighten the Item 4 bolts to hold the post from
rotating.
STEP 3: Attached the Item 5 Speaker Bridge to the Mounting Post and insert the Item 6 Detent Pin
through the Item 5 Speaker Bridge and Mounting Post. The button on the end of the Detent Pin
must be pressed in when inserting or removing the Detent Pin. This is how the speakers are
installed and removed from the tower.
STEP 4: Tighten the Item 7 Locking Set Screw using the Item 8 T-Handle Hex Wrench. This is not
required for smooth water or if double-up’s are not routinely performed. For rougher water the
Locking Set Screw adds an effective stiffening of the speakers to the clamp.
STEP 5: You can aim the speakers by rotating the Mounting Post. We recommend aiming each
speaker 10-15 degrees to the outside of the wake corresponding to the side of the tower the
speaker is mounted on. This will eliminate any phasing or imaging of the speakers and provide a
more balanced sound to the rider as they move across the wake. Once positioned, tighten the
mounting post bolts to 20 ft-lbs.
STEP 6: Attached your amp wires to the binding post and go wakeboarding!
