Monster Moto MM-B212, Руководство пользователя

Страница: 12 / 32

855-833-6483 OR EMAIL US AT SUPPORT@MONSTERMOTO.COM!
PROBLEMS? DO NOT RETURN TO STORE! CALL US AT
10
INSPECTING YOUR MINI BIKE
Before turning on and riding your mini bike, inspect the vehicle to ensure it is in
proper operating condition:
»
Examine the tires for proper inflation and to detect excessive wear.
»
Visually inspect the entire mini bike for damage.
»
Check the engine oil level and the fuel level, and ensure that the fuel cap
and the oil filler cap are securely tightened.
»
Test to ensure that the brakes and the throttle are working properly.
»
Visually inspect the mini bike for fuel or oil leaks.
»
Inspect all nuts and bolts to ensure they are properly tightened.
»
Ensure that the handlebar turns smoothly.
»
Complete any maintenance procedures which are necessary to ensure
your mini bike is in proper riding condition. Do not ride your mini bike if it
is not in operating condition. Refer to the Troubleshooting section of this
manual or call Monster Moto customer service to remedy any problems
you find.
STARTING YOUR MINI BIKE
1.
Turn the engine stop switch to the “on” position, as indicated by the symbol.
2.
Turn the fuel valve lever to the “on” position.
3.
Ensure that the choke lever is in the correct position:
a. If the engine is warm, move the choke lever to the
right, in the run position.
b. If the engine is cold, move the choke lever to the left, in the start position.
4.
Pull the pull starter cord in rapid succession until the engine starts run-
ning. To avoid potential damage to your mini bike, never pull the starter
cord all the way out of its housing.
5.
Once the engine has started, move the choke lever into the “run” position
(right) if it was not already there. Having the choke lever in the “start”
position will help you start the mini bike; however, the mini bike will not
operate properly with the choke lever in the “start” position. Always move
the choke lever to the “run” position once the engine is running.
6.
Once the choke lever is in the “run” position, use your foot to disengage
the kickstand and you are ready to ride!
7.
If the mini bike stops running after you move the choke lever into the “run”
position, repeat the steps above to restart the engine, this time allowing
the engine to idle with the choke lever in the “start” position for one to
two minutes before you move the choke lever into the “run” position. This
will allow the engine to achieve a higher operating temperature.