Monsher MHG 61 BG, Руководство пользователя

Страница: 24 / 56

24
English
CHANGE THE INJECTOR OF THE BURNERS
Remove the pan support, Burner lid and Flame
spreader.
Unscrew the injector using a 7 mm box spanner
and replace it with the stipulated injector for new
gas supply. Carefully reassemble the all compo-
nents. After injectors are replaced, it is advisable
to strongly tighten the injector in place.
ADJUSTMENT OF MINIMUM LEVEL OF THE FLAME
1. Turn the taps down to minimum.
2. Remove the knob from the tap and place a
small bladed screwdriver in the centre of the tap
shaft.
3. The correct adjustment is obtained when the
flame has a length of about 3–4 mm.
— For butane / propane gas, the adjusting screw
must
— be tightly screwed in.
— Refit the control knob.
Make sure that the flame does not go out by
quickly turning from maximum flow to minimum
flow. If it does then remove the control knob and
make further adjustments to the gas flow, testing
it again once the adjustment has been made.
4. Repeat this process for each one of the gas
taps.
�
Do not dismantle the tap shafe: in the event of a malfunction, change
the whole tap.
�
Before placing the burners back on the top lace, make sure that the
injector Is not blocked.
�
A full operational test and a test for possible leakages must be carried
Out after gas conversion. (such as soap water or gas detector).
�
After completing conversion, a qualified technician or installer has
to mark “V” on the right gas category to match with the setting in rating
plate. Remove the previous setting “V” mark.
Injector
Control
handle
Tap
Sealing ring
Adjustment
screw