9
To use the amplifier with remote power on, the Master Power switch on the rear panel
should be in the ON position and the Power switch on the front panel in the Standby
position.
To override the remote power on feature or to use the amp without it, simply use the
Power switch on the front panel to turn the amp on and off (standby).
INSTALLATION
Perform the following steps to install this amplifier into a 7.1-channel audio system.
1.
Power off and unplug all equipment that will be connected to this amplifier.
2.
Prepare seven lengths of speaker wire (not included) to connect each of the seven
output channels to its respective speaker.
3.
Using a two-conductor speaker wire, connect one end to the input terminals on the
speaker, then connect the other end to the Output terminals on the amplifier. Take
care to maintain polarity with positive to positive and negative to negative.
4.
Repeat step 3 for each of the other six speakers.
5.
Using a single RCA interconnect cable (not included), plug one end into the Input on
the amplifier, then plug the other end into the preamplifier output of the same
name.
Example: Connect the Center channel input on the amplifier to the Center channel
output on the preamplifier.
6.
Repeat step 5 for each of the other six channels.
7.
(Optional) Using a two-conductor 3.5mm TS cable (not included), plug one end into
the Trigger Input on the amplifier, then plug the other end into the trigger output
on your source device.
8.
Ensure that the Master Power switch is in the OFF position and that the Power
switch is in the Standby position.
9.
Using the included AC power cable, plug the C19 connector on the cable into the
C20 panel connector on the amplifier, then plug the other end into a nearby AC
power source.
