background image

4. 

Amplifier

 (not shown) - This subwoofer is powered by a 200-watt (RMS) power 

amplifier. This amplifier will provide the driver with all the needed power, while 
ensuring the sound is crisp, clean, loud, and distortion free at all times. 

5. 

Bass Reflex Port

 - This specially tuned port is designed to allow bass signals to 

escape from the rear of the enclosure. The shape and size of this port enhances the 
bass response, resulting in a fuller sound. 

6. 

XLR Inputs

 (Left + Right) - This subwoofer includes a pair of XLR connectors for 

balanced signal inputs. The pin out is printed on the back of the subwoofer and is as 
follows for XLR connectors: 

XLR pin 1 = ground signal (shield) 

XLR pin 2 = positive signal (+) 

XLR pin 3 = negative signal (-) 

7. 

TRS Inputs

 (Left + Right) - This subwoofer can accept balanced or unbalanced TRS 

or unbalanced TS inputs. The TRS input will override the XLR input at all times (i.e., if 
there is signal running into the XLR inputs and a cable is plugged into the TRS input, 
the XLR signal will not come through). The pin out is printed on the back of the 
subwoofer and is as follows for TRS connectors: 

TRS Tip = positive signal (+) 

TRS Ring = negative signal (-) 

TRS Sleeve = ground signal (sleeve) 

8. 

XLR Outputs

 (Left + Right) - This subwoofer includes a pair of XLR connectors for 

balanced signal outputs. These connections output only those frequencies that are 
above the low-pass filter's cutoff point. 

9. 

TRS Outputs

 (Left+ Right) - This subwoofer includes a pair of balanced or 

unbalanced TRS or unbalanced TS outputs. These connections output only those 
frequencies that are above the low-pass filter's cutoff point. 

10. 

Volume Control

 - Rotate this knob clockwise to increase volume and 

counterclockwise to decrease volume. 

11. 

Low Pass Filter

 - This knob will determine which frequencies are sent to the 

subwoofer and which are cutoff and sent to the outputs. Rotate the knob clockwise 
to increase the cutoff frequency to a maximum of 150Hz. Rotate the knob 
counterclockwise to decrease the cutoff frequency to a minimum of 50Hz. 

 

Отзывы: