9
4. Preparations
4.1 Prepare the Remote Control
The provided remote control allows the unit to be
operated from a distance.
•
Even if the remote control is operated within
the effective range 19.7 feet (6m), remote
control operation may be impossible if there
are any obstacles between the unit and the
remote control.
•
If the remote control is operated near other
products which generate infrared rays, or if
other remote control devices using infra-red
rays are used near the unit, it may operate
incorrectly. Conversely, the other products
may operate incorrectly.
4.2 Replace the Remote Control Battery
1
Press and slide the back cover to open the
battery compartment of the remote control.
2
Insert two
AAA
size batteries (included). Make
sure the (
+
) and (
–
) ends of the batteries match
the (+) and (–) ends indicated in the battery
compartment.
3
Close the battery compartment cover.
AA
A
AA
A
1
2
3
Precautions Concerning Batteries
•
Be sure to insert the batteries with correct
positive “
” and negative “
” polarities.
•
Use batteries of the same type. Never use
different types of batteries together.
•
Either rechargeable or non-rechargeable
b a t te r i e s c a n b e u s e d. R e fe r to t h e
precautions on their labels.
•
Be aware of your fingernails when removing
the battery cover and the battery.
•
Do not drop the remote control.
•
Do not allow anything to impact the remote
control.
•
Do not spill water or any liquid on the remote
control.
•
Do not place the remote control on a wet
object.
•
Do not place the remote control under direct
sunlight or near sources of excessive heat.
•
Remove the battery from the remote control
when not in use for a long period of time,
as corrosion or battery leakage may occur
and result in physical injury, and/or property
damage, and/or fire.
•
Do not use any batteries other than those
specified.
•
Do not mix new batteries with old ones.
•
Never recharge a batter y unless it is
confirmed to be a rechargeable type.
4.3 Placement and Mounting
Placement
•
(A) You can place the unit on the table
directly in front of the TV stand, centered
with the TV screen. Or (B) you can mount the
unit on the wall directly below the TV screen.
•
Place the Subwoofer at least 1 meter (3
feet) away from your Soundbar, and ten
centimeters away from the wall.
•
Place the surround speakers in the left and
right positions. For best results, place your
Subwoofer & Surround as shown below.
4.4 Wall Mounting (for unit)
Note:
-
Installation must be carried out by qualified
personnel only. Incorrect assembly can
result in severe personal injury and property
damage (if you intend to install this product
yourself, you must check for installations
such as electrical wiring and plumbing
that may be buried inside the wall). It is the
installer’s responsibility to verify that the wall
will safely support the total load of the unit
and wall brackets.
-
Additional tools (not included) are required
for the installation.
Содержание 42034
Страница 1: ...5 1 2 Dolby Atmos Soundbar SB 600 P N 42034 Instruction Manual ...
Страница 18: ......