13
2.
For each mark, place one of the wall mount brackets against the wall,
with the mark in the center of the notch. Use the level to ensure the
bracket is level, then mark each hole in the bracket, which is where the
two screws will be used to secure the bracket to the wall.
3.
Use a ø5.5 ~ 6.0 mm drill bit to drill a hole at each of the four marked
screw hole locations.
4.
If using wall anchors, insert an anchor into each hole. If they do not
insert fully by hand, lightly tap each anchor with a small hammer to drive
them completely into the wall.
5.
Position each bracket over the holes, then use a #2 Phillips screwdriver
and the wall mount bracket screws to secure each bracket to the wall.
Take care not to overtighten the screws. Ensure that the opening of the
notch is at the top of the bracket.
6.
Remove the two screws at the wall
mount mounting locations on the
rear of the subwoofer. Store them in
a safe place in case you need to use
them in the future.
7.
Install the mounting screws into the
screw holes at the wall mount
mounting locations.
8.
Position the soundbar so the
mounting screws are positioned
over the notches in the brackets,
then slide it down into place.
