8
INSTALLATION
Perform the following steps to install the extender:
1.
Ensure that all equipment to be connected is powered off and unplugged from its
power source.
2.
Place the extender receiver at the remote location.
3.
Using a High Speed HDMI® Cable (not included), plug one end into the HDMI input
on your display, then plug the other end into the HDMI Out port on the receiver.
4.
(Optional) Plug either the IR receiver or IR transmitter into the IR In port on the
receiver. If you want to control the source device from the remote location, use the
IR receiver. If you want to control the remote display from the source location, use
the IR transmitter instead.
5.
If using the IR receiver, position the "bulb" where it can receive signals from your
remote control. If using the IR transmitter, position the "bulb" where it can transmit
signals to the IR receiver on your display.
6.
Route a Cat6 Ethernet cable (not included) from the source location to the remote
location. This cable can be no longer than 164 feet (50 meters) and must be rated for
in-wall use if being routed inside or through the walls.
