Monoprice 16275, Руководство пользователя

Страница: 6 / 7

6
10. If you wish to change the speed of
filament extrusion, use the Speed
Control Buttons (5). There are 8 speed
settings, from 1 to 8, with 6 being the
default.
11. When you are finished printing or
when you want to change filament,
double-press the Filament
Retreat/Mode Selection Button (8) to
remove the filament.
OPERATING NOTES

The pen will automatically go into standby mode if no buttons are pressed for
90 seconds.

When using the [ H ] mode and switching to the [ L ] mode, the pen will
gradually cool down over the course of 90 seconds and will automatically
extract the installed PLA filament.

You can adjust the print temperature on the fly, but by no more than ±15°C.
 When switching modes between [ H ] and [ L ], the pen will remember the
temperature you had last set for each mode in the range 90 ~ 135°C for [ L ]
mode and 135 ~ 195°C for [ H ] mode.
 If the screen shows E1 and the blue LED flashes, or if it shows E2, please
contact Monoprice Technical Support for assistance.
 In the event of any other serious operating error, please contact Monoprice
Technical Support for assistance.