13
MONITOR STAND
Perform the one of the following sets of steps to install the base for the monitor stand.
Models 15481, 15483
1.
Position the base on the stand, fitting the stand into the indentation on the base.
2.
Use the stand thumbscrew to secure the base to the stand.
Model 15482, 15486
1.
Position the base on the stand, with the lock hole at the back.
2.
Press the base down on the stand until it clicks in place.
INSTALLATION
The monitor supports four video inputs, each of which can be connected. However, only a
single video connection is required, any additional video inputs can be used or not as
needed.
1.
Ensure that all equipment that will be
connected is powered off and
unplugged from its power source.
2.
Install the base onto the monitor stand
by following the instructions in the
Monitor Stand section above, or mount
the monitor onto a compatible wall or
desk mount.
3.
Using the included VGA cable, plug one end into the VGA Video Input (8) on the
back of the monitor, then plug the other end into the VGA output of your source
device (e.g., computer). Tighten the thumbscrews on each plug to secure them in
place.