monolith HTP-1, Инструкция по установке и эксплуатации

Страница: 32 / 97

HTP-1 Installation and User Guide Release 1.8.1
2) A 5.1 DTS stream is usually authored with the surround speakers at 110 degrees from the
listening position (see the
​
Speaker Location Diagrams
​
on previous page). A 7.1 speaker setup
places surrounds (sides) at 90 degrees and rear speakers at 135 degrees. Hence a 5.1 DTS signal
is often presented for a 7.1 configuration with the surround signal split between the side and
rear speakers.
3) The full Auro-3D® channel set includes the “Voice of God” (VoG) speaker located directly
overhead and the “Front Center High” or “Center Vertical High” (CVH) speaker on the wall above
the screen. These signals are not directly supported as they are not generated by the other
decoders. Like all of the higher speaker modes, the available signals are mapped to the available
speakers. The VoG signal is routed equally to the two “top middle” speakers, if available. In a
“.4” configuration, the VoG signal will be routed to all 4 upper speakers. The CVH signal is split
between the upper front signals.
4) The Auro-3D® speaker set is in fact “high” channels, not top channels. If you choose to install top
speakers, the Auro-3D® high channels are mapped directly to the top speakers.
Dolby Atmos
™
and DTS-X
™
are object audio systems. This means that sound “objects” do not have to
be located in a fixed channel but instead are decoded to match the available set of speakers. This makes
it possible to move sounds around a room reliably with various speaker configurations. On the other
hand, Auro-3D® is a channel-based system. The fixed speaker locations are therefore reproduced by the
available speakers.
Speaker Setup
Click on the
​
gear
​
icon in the upper right corner of the
​
Web GUI Home Page
​
to access the
​
System
Configuration
​
screen, then click the
​
SPEAKERS
​
tab.
HTP-1 User Manual Page 32 V1.8.1