Monogram ZWL1126SJ, Руководство по установке

Страница: 3 / 16

3
Installation Instructions
CLEARANCES AND DIMENSIONS
• Dimensions that are shown in Figure 1 (for
24”) must be used. Given dimensions provide
minimum clearance. Locate electrical outlet in
the shaded area in the upper left-hand corner
of the cutout. See Figure 4.
• Contact surface must be solid and level. Pay
special attention to the floor on which the
Drawer Microwave will sit. The floor of the
opening should be constructed of plywood
strong enough to support the weight of the
oven (about 100 pounds).
• Check location where the Drawer Microwave
will be installed for proper electrical supply.
• Your oven can be built into a cabinet or wall
by itself or under a gas, under an electric wall
oven, or under selected cook top models. See
use and care manual for list of models.
• Be sure that the clearance of the floor between
the wall oven and the drawer microwave is a
minimum of 2-inches.
• The microwave interior will easily accommodate
a 9” x 13” oblong dish or a bag of microwave
popcorn.
• The oven can also be mounted flush. Please
see instructions for flush mounting included
with the Flush Mount Deflector vent.
24” DRAWER MICROWAVE
MEASUREMENTS
Figures 1 and 2 contain many drawer microwave
measurements for reference when planning the
drawer location.
This drawer microwave can be installed below
any electric or gas wall oven or under selected
cook top models. See use and care manual for
list of models.
Can also be installed using an electrical outlet in
an adjacent cabinet within the areas where the
provided electrical cord can reach. Power cord
access hole in cabinet should be a minimum of
1 1/2” diameter hole and deburred of all sharp
edges.
Always allow sufficient power cord length to the
electrical outlet to prevent tension.
Always check electrical codes for requirements.
24” DRAWER MICROWAVE
MEASUREMENTS (Continues)
.
Anti-Tip
Block
3
1
/
2
”
14
13
/
16
”
to bottom
of Anti-Tip
Block
Floor must
support
100 lbs.
Figure 1
Figure 2
IMPORTANT
(6”)
5”
4”
Allow 1
1
/
16
”
overlap
14
13
/
16
”
opening
Allow
1
/
16
”
overlap
18
1
/
2
” to top
of floor
24”
cabinet min.
36”
countertop
height
Allow
7
/
8
”
overlap
23
1
/
2
”
min depth
Allow
7
/
8
”
overlap
22
1
/
8
”
opening
Suggested electrical
outlet location*
4
11
/
16
”
1
3
/
4
”
4”
21
5
/
8
”
15
15
/
16
”
14
19
/
32
”
15”
auto drawer
opening
21
7
/
8
”
1
1
/
4
”
door thick-
ness
23
7
/
8
”
1” = 2.5 cm; 1’ = 0.3 m