15
Installation
36" Refrigerators, Freezers
Step 5
Level
Refrigerator
or Freezer
All models have 4-point leveling. The front is supported
by leveling legs, the rear is supported by wheels.
• Adjust rear wheels beneath the product to just barely
touch the 2x4 block.
• Turn the 7/16" hex nut located above the front wheels.
Turn to raise or lower the refrigerator.
• For front leveling legs, use a 1-1/4" open-end wrench.
• Adjust carefully, the refrigerator should be level and
plumb with cabinetry, and should align with toekick
height.
Step 6
Secure
Refrigerator
or Freezer
to Sides
When using 1/2" to 3/4" side panels, the front flange of
the case trim is attached to the side panel.
• Open door to access case trim.
• Drill hole in trim slightly below the interior opening.
Drive screw through the trim and into the side panel.
• Follow the same procedure on the opposite side.
If the product is installed between cabinets with no
side panels or in a custom enclosure, install a spacer
block as shown.
• Open door to access case trim.
• Drill hole in trim slightly below interior opening and
drive screw through the trim and into the spacer
block.
• Follow the same procedure on the opposite side.
Note:
Whenever possible,
perform this step for
additional anti-tip security.
This step can be used as an
alternate to Step 4, Anti-Tip
bracket installation,
whenever brackets cannot be
used.
OR
Leveling Leg
Hex Nut Adjusts
Rear Wheels
Stud
Spacer
Block
Refrigerator
Cabinet
Door
Step 8
Install 1/4"
door panels
Step 7
Connect
Freezer
Water
Supply
Check to be sure that power cord IS NOT plugged into
the wall outlet.
• Locate and bring copper tubing to the front of the
cabinet.
• The copper tubing should be just long enough to
reach the coupling. Excess tubing length could
interfere with door closing or toekick installation.
• Slip a 1/4-1/4 union nut (provided) over both ends of
the copper tubing at the left front leg and couple the
lines.
• Turn on the water to check for leaks.
If you are using a 3/4" thick custom panel, SKIP THIS
STEP. See Custom Panel Dimensions pages for panel
sizes with ZKTR36LH or ZKTR36RH trim kit and other
kits. Refer to trim kit installation instructions in this
booklet.
• Open door to 90
°
stop. Remove the Phillips head
screws from the aluminum trim door handle.
• Remove handle. Retain all screws and handle.
• Slide custom panel into the door trim.
• Replace door handle and secure with original screws.
