Monogram ZDBC240, Руководство по установке, Страница: 6 / 24

6
31-46122-7
STEP 2 REVERSE DOOR SWING
(Cont.)
Reinstall the door:
• Install the original door stop and cam riser onto the
bottom left side of the door.
• Install the new supplied bottom case hinge pin and
bracket onto bottom left side.
• Place the door onto the bottom case hinge.
• Install the supplied left-hand top case hinge with the 3
original screws.
• Select the hinge cover marked with an “L”.
• Peel backing off the tape inside the decorative hinge
cover.
• Press and snap the hinge cover into place.
• Snap the screw hole cover into place on the opposite
side.
IMPORTANT:
Check to be sure screws are tight and that the door is
straight and does not sag. The door should swing freely.
Installation Instructions
Install Covers
Remove
Top Hinge
Remove
Hinge
Install
3 Hinge
Screws
Door Stop
and Cam Riser
Hinge
Pin and
Bracket
STEP 1 REMOVE PACKAGING
• Remove corner blocks and foam drawer stops.
• Remove all packing material, tape and protective
plastic coverings.
• Remove stainless steel toekick taped to the back of the
unit.
WARNING
Small objects are a choke hazard for
children. Remove and discard any parts not used.
STEP 2 REVERSE DOOR SWING
SKIP THIS STEP IF DOOR SWING SUITS THE
INSTALLATION
WARNING
Follow all steps when reversing the
door swing. Failure to follow these instructions, leaving
off parts, or overtightening screws, can lead to the door
falling off and result in injury and property damage.
Parts Included:
• Top left case hinge
• Bottom left case hinge
• Left and right side decorative hinge cover
• Decorative hinge screw hole cover
• Torx
®
driver bit
Tools Required:
• Phillips screwdriver
• Electric drill
Remove the door:
• Flatten the shipping carton to use as a pad.
• Remove the 2 screws and the toekick. Set aside the
screws and toekick for final installation.
• Use the supplied Torx
®
bit and electric drill to remove
the 3 screws holding the top case hinge. Lift off the
hinge. (Screws will be used to install the new hinge.)
• Lift the door off the bottom case hinge.
• Remove the bottom case hinge pin and bracket.
Rotate the door:
The handle will be on the right side of the door; hinges
will be installed on the left side of the case.
• Remove the door stop and cam riser on the original
bottom right side of the door.
• Remove the fill plug on the top right side of the door.
• Turn the door over and reinstall the fill plug on the new
left side.