Monogram ZBD3000, Инструкция по использованию и уходу

Страница: 7 / 28

DOOR LATCH “OFF “POSITION
SELECTED CYCLE INDICATOR LIGHTS
I
SOIL OPTIONS
N O R M A L L I G H T WASH HEAT
SOIL SOIL SOIL BOOST
m,
Step 4. Select a soil option
If you wish to make program
changes, start with the soil level.
You should select a change within
30 seconds, otherwise all panel
lights will go out. To relight, touch
any pad or open and
door.
. HEAVY SOIL should be selected
when dishes are extra soiled or
extra greasy. This gives dishes
an extra rinse in every cycle
except RINSE & HOLD. This
lengthens cycle.
●
NORMAL SOIL is automatically
programmed when a cycle is
selected. You may want to change
the selection depending on the soil
on your dishes.
●
LIGHT SOIL will save time
and money if you
your dishes. This shortens all
cycles except RINSE & HOLD.
Step 5. Select a drying option
●
HEATED DRY on—Provides
faster drying. Can be changed
while cycle is running.
●
HEATED DRY off (Energy
Saver)—Shuts off heating unit.
Dishes air-dry naturally. It takes
longer, but saves energy. You can
prop door open about 3 inches
after motor stops to speed drying.
Excellent for overnight drying.
The Energy Saver (Heated Dry
helps reduce the energy used by this
model approximately
●
WASH HEAT BOOST. See How
to Test Water Temperature section.
The entering water must be
between
and Use
wash heat boost option when
water is less than
When selected, the wash
cycle will be extended for 30
minutes while the dishwasher
heats the water for good washing
and drying.
Step 6. Start dishwasher
●
When you’re ready to wash
dishes, touch the START pad.
There is a time delay between
start-up and water fill so you will
not hear any wash action right
away. Dishwasher will proceed
through your entire program and
turn off automatically.
To delay the start, touch DELAY
START pad. The SYSTEMS
MONITOR will read”1
delay.”
Touch pad once again for each hour
desired up to 14 hours. The machine
will count down and start
automatically at the correct time.
NOTE: Don’t forget to put
detergent in cup and close cup.
Do not use DELAY START with
the RINSE & HOLD cycle.
To change a cycle after washing
starts, touch the CLEAR RESET
pad to cancel cycle. After water
is pumped out and motor stops,
you can reprogram and restart
the dishwasher.
7