Monogram WX08X10002, Руководство по установке

Страница: 5 / 16

WARNING
Under certain circumstances, this refrigerator
can tip forward.
Injury to persons can result.
Install Anti-Tip Bracket packed with this refrigerator.
Installation Instructions
5
STEP 2 LOCATE ANTI-TIP BRACKET
A. Place the anti-tip floor bracket locator template
(included inside the anti-tip kit) onto the floor up
against the rear wall, within W, and in line with the
desired location of the RH side of the refrigerator
(see Figure 1).
B. Place the anti-tip floor bracket onto the locator
template with its RH floor holes lined up with the
floor holes indicated on the template sheet, approxi-
mately 7-1/4” from the edge of the sheet or the RH
side of the refrigerator.
C. Hold down in position and use the anti-tip floor
bracket as a template for marking the holes based
upon your configuration and type of construction
as shown in Step 3. Mark the hole locations with
a pencil, nail or awl.
Floor - Concrete
(2 Holes)
Floor - Wood
(2 Holes)
Base
Bracket on
the Refrigerator
RH Holes
7 1⁄4”
Rear RH
Corner of
Cabinet Wall
RH Side of
Refrigerator
Locator
Template
Sheet
2 Wall Holes
Floor Bracket
to Install
Figure 1 – Installation Overview
NOTE:
It is REQUIRED to use at least 2 screws to
mount the floor bracket (one on each side of the
anti-tip floor bracket). Both must be into either
the wall or the floor. Figure 2 indicates all the
acceptable mounting configurations for screws.
Identify the screw holes on the anti-tip floor bracket
for your configuration.
STEP 1 MEASURE CABINET OPENING
AVAILABLE VS. REFRIGERATOR
WIDTH
Measure width of cabinet opening where refrigerator
will be placed, W.
Be sure to account for any countertop overhang,
baseboard thickness and any clearance desired.
Width, W, should not be less than 36 inches.
The refrigerator will be placed approximately
in the middle of this opening.
Rear Wall
REFRIGERATOR
RH Side
Baseboard
Thickness
or Countertop
Overhang
(Whichever
is Greater) Plus
Any Desired
Clearance
Front
W