Mono FG166-G11LH, Настройка и эксплуатация

Страница: 56 / 70

MX Eco-touch Rotary Rack Gas Oven (FG166)
Rev. B21 21-05-21
MONO EQUIPMENT
56
DO NOT ATTEMPT TO MAKE ADJUSTMENTS UNLESS YOU ARE
FULLY AWARE OF THE RESULTS
Setting the air slots
The oven has an air panel situated in the rear right-hand corner of the baking chamber
with adjustable slots, which are accurately set prior to leaving the factory (the factory
settings are given in the diagram below). It is through these slots that heated air passes
into the baking chamber to perform the baking task. However, external factors can
negatively affect the baking result, such as a poorly designed baking programme or the
combination of trays and products to be baked, and adjustment of the air slots may be
necessary.
However, before making adjustments please consider the following:

Make sure that differences in baking results are not due to differences in product
batches;

Make sure that the plates that determine the width of the air slot have not come
loose thereby causing a change from the factory setting;

Do not be too hasty in changing air slot settings in response to a sudden change in
bake evenness as this may have been caused by other factors, such as, after
maintenance of the oven, or a related fault with the oven. Any adjustments to the air
slots would be unlikely to cure bake unevenness under these circumstances;

Check that the air circulation fan’s rotation is correct – especially after maintenance
or replacement.
If it is considered that adjustments to the air slots are necessary, these should be made in
small increments and one slot at a time. Measure the slot opening before adjustment then
slacken the screw(s) associated with the slot that requires adjustment, adjust slot opening
then retighten screw. Measure slot opening after adjustment is complete to confirm the
desired dimension has been achieved.
A
B
C
D
E
F
A
B
C
D
E
F
Factory settings:
A = 5.9mm
B = 4.8mm
C = 4.8mm
D = 4.8mm
E = 4.8mm
F = 5.9mm