Mono Machines SHREDDER, Руководство по эксплуатации, Страница: 6 / 22

5. Transportation, installation
• Place the shredder in its packaging on a smooth, level surface.
• Remove the packaging.
• Roll the Shredder off the pallet.
• If you need to move the shredder through narrow doors, you can wait until it is at its final location before
fitting the loading tray. Without the tray, the machine is only 31.5“ wide.
• The shredder can be moved on its rollers.
• When moving the shredder use caution; remember the high center of gravity.
• The shredder may only be placed in dry rooms on a hard, level floor — not on carpets. The floor load on
each roller is approximately 396.8 lbs.
• If using a forklift to transport the machine, you must first remove the waste trolley. Then you can push the
forks under the machine from the left or right side and lift up.
• Place the machine in such a way that the power plug is easily accessible and the ventilation slots are free.
• Fitting the loading tray:
Fasten the tray on both sides at the top with the Phillips screws (1) and at the bottom with the 2 nuts (2).
1
2
• Solo machine:
- Lock the front castors by pressing down the brake lever.
- Connect the power plug of the shredder to the 32A CEE main socket.
• Combination version:
- The assembly of the shredder with the baling press is described in the operator‘s manual of the Shredder
press combination.
• The machine must be connected to a power source which meets the specifications on the nameplate.
• Make sure the power cable is unobstructed and that nobody can tread on it.
• No platforms or other raised surfaces may be placed near the shredder if they encroach on the specified --
safety clearances.
http://www.monomachines.com
http://www.monomachines.com