Monitor Audio PL100 STAND Platinum series, Руководство пользователя

Страница: 29 / 40

Positioning
The positioning for the Platinum Loudspeakers will be different for every single application.
This is due to the individual room’s acoustic properties and personal preference; every
room is different. We can advise you on ideal positioning as best as we can drawn from
years of loudspeaker experience.
None of the Platinum Series speakers are shielded. This means that if positioned too close
to a CRT television screen, distortion can occur. When positioning them next to a CRT
television be sure to site them far enough away to avoid distortion to the screen.
PL100
When the PL100 is used with the Monitor Audio bespoke stands, the height of the
speakers should be so that the tweeter is approximately ear height. If this cannot be
achieved, the listening angle can be adjusted to fire them direct at the listening position.
This is achieved by adjusting the feet on the front and back of the stands. The same
applies when not using our stands, however, adjustment is limited to that of the
particular stand used.
When used in 2 channel, they should be positioned approximately the same distance
apart as you sit from them, approximetely 20 -50 cm from the rear wall and a minimum
of 50cm from side walls.
If you must have your speakers further apart than the ideal, ‘toeing’ them in a bit more to
a centre point can help to create the optimum central sweet spot.
For further positioning suggestions please refer to the images on page 25
PL300
When used in 2 channel they should be positioned approximately the same distance apart
as you sit from them, approximetely 0.5 - 1.5m from the rear wall and a minimum of 1m
from side walls.
If you must have your speakers further apart than the ideal, ‘toeing’ them in a bit more can
help to create the optimum central ‘sweet spot’.
For further positioning suggestions please refer to the images on page 25
PLC350
For those with acoustically invisible screens, the centre channel should be placed
behind it (in the middle), again ideally with the tweeter at ear height or no
more than 5°. The Monitor Audio PLC350 stand can be modified to tilt the loud
speaker upwards. This is achieved by swapping the front and back speaker supports to
provide a steeper angle. To do this, please refer to the stand assembly instructions.
If you are using another type of display system, place the centre channel directly below
(again in the middle) of the screen. Once again, the listening angle can be adjusted
accordingly by following the assembly instructions with the stand.
For further positioning suggestions please refer to the images page 25
24
monitoraudio.co.uk