ASSEMBLY STEPS
•
WARNING!
Adult assembly required.
•
Note:
Some parts might be factory assembled.
•Care should be taken in unpacking and assembly of the vehicle. Do not allow the children to play with any of the parts or to
help in the assembly of the vehicle. Risk of injury due to small parts, sharp edges and sharp points in the
vehicle’s
unassembled state.
• Identify all parts before assembly and save all packing material until assembly is complete to ensure that no parts are
discarded
• After each step you must check if each part is correctly placed and well fixed. Follow strictly each step and study well the
assembly figures.
• Assembly tools needed: screwdriver (not included in the set) and spanner (not included in the package).
•
DO NOT
over-tighten in order to avoid any damage.
If you find problems with assembly, contact the store from where you purchased the product.
1.Step 1 - Installing the front fender and front fork - See Figure 1:
Thread the front fork through the fender opening. The
plastic cover must fit into the fork.
2.Step 2 - Installing the steering fork and the handlebar - See Figure 2:
Take the steering fork that the front wheel is
already attached. Insert it through the hole of the body of the tricycle. Attach the handlebar to the tip of the steering fork.
Secure with screws.
3.Step 3 - Installing the rear view mirrors - See Figure 3:
Insert the right rear view mirror into the holes of the steering
wheel. Press until you hear a click sound. Install the left rear view mirror the same way.
4.Step 4
– Installing the front wheel - See Figure 4:
Take the front wheel and place it in the middle of the front fork. Put
the front axle through the front wheel. Then insert the washer and tighten it with a nut and a wrench. Finally, put the caps on
the wheel.
5.Step 5
–Installing the windshield and the headstock - See Figure 5
: Firstly, attach the wire coming out of the
headstock to those coming from the motorbike`s body. Take the headstock and attach its wires to the wires of the front part
of the body. Attach the windshield to the front of the tricycle body. Secure with a screwdriver and screws.
6.Step 6 - Installing the pedals - See Figure 6
: Connect the power cord to the right pedal. Attach the pedal to its intended
place and press until you hear a click sound. Do the same with the left pedal.
7.Step 7 - Installing the rear wheels and the exhaust pipe - See Figure 7:
Attach one cogwheel onto each side of the two
rear wheels. Take the rear axle, put it through the rear left wheel, the rear part of the body and the rear right wheel. Put a
washer and a nut on both sides of the rear axle. Fix with a wrench. Finally, put caps on. Attach the exhaust pipes on each
side of the rear part of the
motorbike’s body. There are holes in the rear to each you must attach the pipes. Push them until
they are fixed.
USE OF THE PRODUCT
Notice:
When you change the direction of movement, first make sure that the motorbike is not in motion. Otherwise, if you
change the direction of movement suddenly without stopping the motorbike first, the gears and motor may get damaged.
The power key is on the handlebar. The Forward
– Stop - Backward button and the music panel are in the middle of the front
body. The pedal is placed on the right side of the body. See Figure F and U.
1.Moving forward - backward:
Switch the power KEY on and the motor is switched on. Press the button for
“▲ Forward –
Stop -
▼ Back” in position “▲ Forward”. Press the pedal and the motor will start moving forward. .Move to position ▼Back
and press the pedal, the product will start moving backwards. Release the pedal and the motorbike will stop moving.
2.The battery operated motorbike will stop automatically, when your child lifts its leg from the pedal.
3.Put the
▲stop▼ button in position stop and the motor will stop moving.
4.Music player (panel):
A.USB slot
–
only supports MP3.
B.AUX input
– Allows a cable to be connect to portable MP3 player or phone with the music player of the car
C.Adjusting the volume/ melodies
–
long press to turn the volume up.
D.Storytellling and ABC;
E.Decreasing the volume
– long press in order to turn the volume down.
Do not put the MP3 player close to the ears and do not listen to loud music, because this may lead to
impairment of the hearing.
13
REMOVAL OF THE DISCHARGED BATTERY
• Your sealed lead-acid battery must be recycled or thrown away in an ecologically sound manner;
• Do not throw the lead-acid battery in fire. The battery may explode or leak.
• Do not throw the lead-acid battery with your domestic waste. The incineration, land filling or mixing
of sealed lead-acid batteries with household waste is forbidden by Law.
• Take the discharged battery to a station for recycling of lead-acid batteries or to a seller of batteries
for cars.
Содержание NEL-R1600GS
