ShockDisplay curve
3.
Battery replacement
-
If a "new battery" has been configured, unscrew the side battery cover and insert 2 new
batteries of the selected battery type.
Important:
The device must always be switched off to change the battery.
4.
Installation on site
-
Mount the device at a vibration-proof position of the goods to be transported and switch it on
with the button
only after installation. Only in this way the rest position can be found and
premature erroneous recording avoided.
5.
After transport
-
Switch off the device so that only the relevant measured data is stored in the memory.
( press
until the display shows “switch off with SET“, than press
)
-
Then unmount the device
If the device is password protected or if extended functions such as pre-programmed start / stop times
is used, then a look at the user manual is essential.
