Mongoose VT401, Руководство пользователя

Страница: 13 / 16

13
Insert a SIM Card (not supplied) – ensure no power is connected
Before connecting any power to this tracker, remove the 4 screws at the antenna end
of the module. Withdraw the printed circuit board from the case. Notice the SIM card
slot. Slide the SIM card fully into the slot noting the correct orientation. Refit the circuit
board and replace the screws.
Wiring connections
Red - per12V
Black – ground (-)
Yellow – car alarm & SOS (-) (relay required for + positive sirens)
Purple - engine immobiliser (-) (optional connection – relay required)
Connection of the SOS button and vehicles car alarm (if vehicle equipped)
For (+) positive siren connection (Fig A);
Use a suitable low impedance miniature relay, not supplied, to convert positive siren
output to negative and connect as shown in the diagram below.
For (-) negative siren connection (Fig B);
No relay required, connect siren trigger wire to yellow wire of with a diode in-line to
prevent pressing SOS button sounding the siren.
Fig A Fig B
Note: Alarm feature inoperative from a pulsed horn honk - input must be constant ground
for 10 seconds.
ENGINE IMMOBILISER RELAY
(NOT SUPPLIED)
(-) Purple
GPS tracker
8
8
8
3
87
+12V
LOW CURRENT STARTER

CUT