Monessen Hearth Artisan AVFL42NIP-BU, Руководство по установке

Страница: 26 / 44

U)
Monessen • AVFL Series Installation Manual • 4099-901 Rev. E • 01/22
A. General Information
WARNING! Risk of Shock or Explosion! DO NOT wire
110-120 VAC to the valve or to the appliance wall switch.
Incorrect wiring will damage controls.
NOTICE: This appliance must be electrically wired and
grounded in accordance with local codes or, in the absence
of local codes, with
National Electric Code ANSI/NFPA
70-latest edition .
• Wire the appliance junction box to unswitched 110-
OUz D67 ! & &
x 6 OOzOUz D67 &
with ground-fault circuit-interrupter protection, in
compliance with the applicable electrical codes, when
it is installed in locations such as in bathrooms or near
Q
x OOzKOUz D67
$
6
Electrical Information
Electrical Service and Repair
WARNING! Risk of Shock! Label all wires prior to dis-
connection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper
operation after servicing.
WARNING! Risk of Shock! Replace damaged wire with
type 105º C rated wire. Wire must have high temperature
insulation.
Junction Box Installation
WARNING! Risk of Shock! Label all wires prior to dis-
connection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper
operation after servicing.
WARNING! Risk of Shock! Replace damaged wire with
type 105° C rated wire. Wire must have high temperature
insulation.
Accessories Requirements
x ! 6D| 6D)z
ˆ ! 6D|U
6D|U?< Q
! Q ?<
switches and wiring to control the lights as well as a wall
ˆ
N & ; J ; !
Figure 6.1 - Cover Plate for Junction Box
Junction Box Wiring
O ! & &
N
U ! \ $ '$ &
G > 6& -
Electrical connections should only be performed
& !_! ! `
&`> ! !
power supply or performing service. All wiring
shall be in compliance with all local, city and
state codes. The appliance, when installed,
must be electrically grounded in accordance
with local codes or in the absence of local
codes, with the National Electrical Code ANSI/
NFPA 70 (latest edition) and Canadian Electrical
Code, CSA C22.1.
CAUTION
Label all wires before disconnecting when
servicing controls. Wiring errors can cause
improper and dangerous operation.
Do not connect wall switch to 110 V circuit.
Figure 6.2 - Junction Box Wiring Diagram
120V AC
60Hz
Factory Supplied
Not Supplied
Junction Box
WARNING
WARNING
Cover Plate for
Junction Box
necting the wires, route the wire leads through this
'& )U