Moneris smartselect, Руководство по эксплуатации

Страница: 42 / 198

Configuring Your Terminal
32 SmartSELECT Merchant Operating Manual v 2.0
8. Press
Exit
to complete the screen configuration. The
Terminal Configuration
menu reappears.
4.6.2: Printer Control
This function allows you to test the printer density settings and select the setting
you prefer.
From the Idle screen:
1. Press
Menu
. The
Financial Transactions
menu appears.
2. Press
Config
. The
Terminal Configuration
menu appears.
3. Scroll down and select
Printer Control
. The
Swipe Admin Card
prompt
appears.
4. Swipe the POS Admin Card. The
Printer Density
prompt appears.
5. Select the option you prefer. The default is
Medium
. The printer will print a
single line at the density you selected.
6. Press
Enter
to select that printer density. The
Terminal Configuration
menu
reappears.
4.7: Communications Parameters
Use the General Parameters function to reconfigure the communication properties
From the Idle screen:
1. Press
Menu
. The
Financial Transaction
menu appears.
2. Press
Config
. The
Terminal Configuration
menu appears.
3. Select
General Parameters
. The
General Parameters
menu appears.
4. Select the parameter you would like to change.
4.7.1: Communications Type
To select the communication type:
From the
General Parameters
menu:
1. Select
Communications Type
. The
Communications Type?
prompt appears.
2. Select the communication type your SmartSELECT uses to communicate
with the Moneris Host.
• If you select
Dial
, the
General Parameters
menu reappears with list items 2
through 6 disabled. Go to section 4.8: Dial Communications Parameters .
• If you select
3201
, the
General Parameters
menu appears with
3201 Poll
Code
enabled. Go to section 4.9: 3201 Direct Communications Parameters .
• If you select
LAN
, the
General Parameters
menu reappears with
LAN Mas-
ter Terminal
,
LAN Address
and
3201 Poll Code
enabled. Go to 4.10.1: Con-
figure Terminal as LAN master station OR 4.10.2: Configure Terminal as LAN
slave .