m
|
o
|
n
|
d
|
i
TM
your custom size, simply use one of the pre-cast saw grooves to cleanly cut
through the plastic.
OPERATION
W
ARNING
– H
AZARDOUS
VOLTAGE
. C
AN
SHOCK
,
BURN
OR
CAUSE
DEATH
.
D
ISCONNECT
POWER
BEFORE
MOVING
OR
INSPECTING
PUMP
.
1. The pump must be submersed in at least 1’(30cm) of water to operate - for
continuous operation complete submersion is preferable to prevent the
motor from overheating.
2. The pump will remove water down to 1/2”(1.0cm) in ideal conditions. If the pump
is operating and no water comes out of the discharge line, shut off the power
immediately. The water level is likely very low and the pump is no longer primed.
3. The pump is designed to pump cool water only. Pumping heated water, or liquids
other than water can overheat the motor. Do not pump flammable liquids - there
is a risk of explosion.
4. Keep the pump inlet free of debris or foreign material at all times – if required, use
a raised base for the pump to sit on (see
Installation 1
). We also recommend
using a pump bag or filter to extend the life of your pump.
OPERATION
OPERATION
!
FIG 1.1
CUSTOM
FITTING
SIZES
INCLUDE
:
0.50”
|
0.75” | 1.00”
|
1.25”
GARDEN
HOSE
FITTING
:
Standard
0.50”
SAW
GROOVE
FIG 1.2
4
