5
3.1 Internal Mode - Standard Strobe Operation
In the
Internal Mode
the stroboscope generates it’s own frequency
variable speed signals and functions like a typical stroboscope. This is
the default start up mode.
The rubber tuning button functions as a
joystick. The tuning button is sensitive
in four directions. Place your thumb on
the button and use a rocking motion
(forward, back, or side-to-side) to
control it (see Figure 4). It is possible to
adjust the strobe in 0.1 FPM increments.
To change the flash rate:
1.
Press the tuning button. The last digit changed will begin blinking.
2.
Rock the tuning button to the left or right to select which digit to
change. The digit blinking is the one to be changed.
3.
Rock the tuning button up or down to increase or decrease the
value of the blinking digit. The digit will stop blinking after 5 blinks
and the strobe will continue to flash at the new flash rate.
To multiply or divide the current flash rate by 2:
1.
Press the MODE button once. The
÷2 ×2
icon will be displayed.
2.
Rock the tuning button to the left for
÷2
or right for
×2
. (Rocking
the tuning button up or down while in the
÷2 ×2
Mode
will have
no effect.)
3.
Repeat steps 1 and 2 each time you want to multiply or divide the
flash rate.
Note:
If a multiply or divide operation will exceed the limits of the unit,
upper limit or lower limit, the display will indicate OVER or
UNDER and no change will be made to the flash rate.
Figure 4 Tuning Button
