®
the sliding switch (2) must be set to MAG. PHONO or AUX. For cas-
setteV/audio tape operation use the AUX input, cinch jack PB (14).
Operation
1) At first set the controls (1+ 4) to “0” position.
2) Connect the mains plug to the mains supply (230 V~/50 Hz). After
switching on the operating LED ON (8) is lighting.
3) Set the input controls (1) as well as the tone controls (3) to the desired
values.
Adjust the overall volume with the MASTER control (4). The VU meter
(5) displays the output level.
Microphone Priority Circuit
With the microphone channel 1 an actual music programme (in the AUX/
PHONO channel 4) can be talked over for announcements etc. while the
music is automatically attenuated down to 20 dB. There is a soft fading in
and out.
With counterclockwise position of the FADER control (16) at the rear this
function does not work. With turning this control clockwise to the end stop
the max. music attenuation is adjusted.
Battery Operation
The 24 V battery connections (11) are at the amplifier rear. If the 24 V volt-
age is connected, the amplifier is in operation immediately. The LED ON
(8) is lighting. The power switch (7) is out of function.
If 230 V alternating voltage and 24 V direct voltage are connected at the
same time, then the amplifier operates with mains. In case of mains failure
it automatically switches over to battery operation.
Circuit breaker
In case of short-circuit or overload a circuit breaker (9) automatically opens
the circuit, the LED PROTECT (6) is lighting. After removal of the error this
switch (9) can be closed again.
Specifications
Output power: . . . . . . . . . . . . . 100 W max.
THD: . . . . . . . . . . . . . . . . . . . 2 %/60 W
Outputs
Speakers: . . . . . . . . . . . . . . 4/8/16
Ω
, 70/100 V
Preamplifier (jack REC): . . . 200 mV (20-20 000 Hz, ±1 dB)
Line Out . . . . . . . . . . . . . . . 1 V/600
Ω
Inputs
MIC/LINE 1-3: . . . . . . . . . . MIC 0.5 mV/3 k
Ω
(for low imped. mikes)
switchable to line level 120 mV/220 k
Ω
MIC 4/AUX/PHONO: . . . . . MIC 0.5 mV/3 k
Ω
(for low impedance
microphone) switchable to
MAG. PHONO 3 mV/47 k
Ω
(RIAA) or
AUX 200 mV/250 k
Ω
Frequency Range: . . . . . . . . . 50-15 000 Hz, ±3 dB
Tone controls
Bass: . . . . . . . . . . . . . . . . . ±10 dB/100 Hz
Treble: . . . . . . . . . . . . . . . . ±10 dB/10 kHz
S/N ratio: . . . . . . . . . . . . . . . . > 60 dB
VU meter: . . . . . . . . . . . . . . . . 0 dB at 60 W
Power supply: . . . . . . . . . . . . . 230 V~/50 Hz, 24 V
ext., approx. 6 A
Dimensions (W x H x D): . . . . . 385 x 125 x 280 mm
Weight: . . . . . . . . . . . . . . . . . . 10.8 kg
According to the manufacturer. Subject to technical change.
Subject to technical change. Copyright © by INTER-MERCADOR GMBH & CO. KG, Bremen, Germany. All rights reserved. 09.95.02
PA-802
Best.-Nr. 17.0120
0
2
4
6
8
10
0
2
4
6
8
10
0
2
4
6
8
10
MIC 1/LINE 1
MIC 2/LINE 2
MIC 4
AUX/PHONO
BASS
MASTER
PROTECT
POWER
ON
+6 dB
+3 dB
+0 dB
-3 dB
-6 dB
-10 dB
-20 dB
+8
6
4
2
0
2
4
6
-8
MIC 4
AUX
MAG PHONO
PA-802
8
6
4
2
0
TREBLE
0
2
4
6
8
10
MIC 3/LINE 3
OUTPUT
LEVEL
PA AMPLIFIER
®
1
2
3
4
5
6 7
8
GB Operating Instructions
PA Amplifier PA-802
A very efficient mono PA amplifier in professional quality for 230 V~/50 Hz and
24 V DC operation. Due to the silicon technique the complete amplifier is
insensitive to temperature changes. Extensive protection circuits are installed.
Safety Notes
This unit uses lethally high voltage (230 V~). To prevent a shock hazard
do not open the cabinet. Leave servicing to authorized skilled personnel
only. Besides any guarantee claim expires if the unit has been opened.
For the operation also watch in any case the following items:
•
The unit is only suitable for indoor use.
•
Avoid excessively warm locations for the unit or high humidity.
•
Do not set the unit into operation and immediately take the mains plug
out of the mains socket if:
1. damage at the unit or mains cable can be seen.
2. a defect might have occurred after a drop or similar accident.
3. there are malfunctions.
The unit must in any case be repaired by authorized skilled personnel.
•
Never pull the mains plug out of the mains socket by means of the mains
cable.
•
If the unit is used for purposes other than originally intended, if it is oper-
ated in the wrong way or not repaired by authorized skilled personnel,
there is no liability for possible damage.
•
For the cleaning only use a dry cloth for dust removing, by no means
chemicals or water.
•
Important for U. K. Customers!
The wires in this mains lead are coloured in accordance with the follow-
ing code:
green/yellow = earth
blue = neutral
brown = live
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
1. The wire which is coloured green and yellow must be connected to
the terminal in the plug which is marked with the letter E or by the earth
symbol
, or coloured green or green and yellow.
2. The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black.
3. The wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured red.
Warning - This appliance must be earthed.
Output Connections
There are terminals (10) for 4,8,and 16
Ω
impedance.
On a separate terminal strip (12) there are connections for 70 V and
100 V with the facility to use them without ground or chassis connection.
Pramplifier and Line Outputs
These outputs are provided as cinch jacks REC (15) and
1
/
4
” jack LINE
OUT (17) at the amplifier rear.
Input Connections
The input jacks (13, 18, 19, 21) are connected as desired. Set the selec-
tor switches MIC/LINE (20) for the inputs MIC/LINE 1-3 (21) to the cor-
responding positions. If a turntable with magnetic system is connected to
the
1
/
4
” jack MAG. PHONO (19) or a source to the auxiliary input AUX (13),
230V~ 50 Hz
0,8 A T
CIRCUIT BREAKER
5 A
GND
COM
4
Ω
8
Ω
16
Ω
24 V DC
COM
70 V
100 V
MIC
LINE
1
MIC
LINE
2
MIC
LINE
3
MIC 4
AUX
MAG.
PHONO
LINE
OUT
REC
PB
FADER
MIN
MAX
9
10
11
12
13 14 15 16 17 18 19 20
21
