Molpir M-374, Руководство по установке

Страница: 34 / 40

Additional functions for active safety
False trigger
Necessary condition: False trigger function F3 must be activated.
If main trigger zone is activated 3 times within 5 minutes next trigger will not be accepted by the system.
If warning trigger zone is activated 5 times within 5 minutes next trigger will not be accepted by the
system.
To restore normal operation of the system must be disarmed and armed again.
Additional control functions
Remote control of Channel output (CH2)
•
remote open of the trunk
•
remote control of car windows opener
•
remote control of ignition support output
•
remote control of various outputs
Mode 1: (F12-1)
Press and hold for 1.5 second button 4, siren chirps once and negative output CH2 will be active for 0.8
second.
Mode 2: (F12-2)
Press and hold for 1.5 second button 4, siren chirps once and negative output CH2 will be active until
alarm trigger.
During active CH2 output press and hold button 4 for 1.5 second, siren chirps long tone and output CH2
will be deactivated.
Mode 3: (F12-3)
Press and hold for 1.5 second button 4, siren chirps once and negative output CH2 will be permanently
active.
During active CH2 output press and hold button 4 for 1.5 second, siren chirps long tone and output CH2
will be deactivated.
Programmable options (functions set up)
Entering functions programming mode
1. Disarm the system (by remote control or by valet switch).
2. Turn ignition ON.
3. Within 3 seconds press valet switch 5 times, siren chirps long tone to confirm.
4. Within 3 seconds turn ignition OFF, siren chirps one short and one long tone to confirm.
5. Within 3 seconds turn ignition ON to enter functions programming mode; system is in F1
programming mode, LED flashes once and siren chirps 1 to 4 times according to actually set
parameter of function F1.
When in functions programming mode:
•
each time valet switch is pressed next function F1 to F12 is selected.
•
LED flashes correspondingly to serial number of the function with using method:
o
LED quickly flashes for numbers 1 to 4
o
LED long flashes for number 5
o
for example function F7 is indicated by one long flash + 2 quick flashes.
•
when desired function is selected then every press of button 1 of remote control will move among
set-up items of the function and siren chirps 1 to 4 times to the corresponding set-up item.
6. to exit functions programming mode turn ignition OFF or just wait 15 seconds, siren chirp one short
and one long tone to confirm.
7. in following table default settings are highlighted by bold characters.