Page 11 of 24
Inspection Diagram after Service and Repair
MOLIFT Smart 150
Service:
Checked service lamp if service is necessary: YES (yellow or red light) / NO (green light)
Use Molift Servicetool and read the lifters data - check number of lifts left before service: _____________________
Service is completed : - Worn or damaged parts, or malfunctioning parts, are replaced. See description for parts
replacement.
Service light was reset using Molift Servicetool. N.B.: The service light must ONLY be reset after completed service!
Perform safety inspection after service.
Safety Inspection
The lift has been visually checked for damages, malfunction and deformation, and it is in order. Checked that lifting
column is properly fastened to chassis, and that the lifter has no loose parts.
Checked that mounting of column works correct. With legs in outer position (working position), it is possible to run
the column up and down easily, and the column falls in place in the base. With lifter in transport position it is not
possible to leave the column in upright position (it falls down when pushing slightly)
Checked that remote control works and that wire and socket for remote control are undamaged.
Checked that the lifter functions correctly and runs without load all the way up and down without abnormal noise.
Checked that end stop works. Repeated test with a load of approx. 100 kg.
The suspension and lifting arm are checked visually for damage, play and deformations. The suspension shall be
turned 360° with some friction. If no defects or malfunctions are discovered, the suspension shall be tested with
maximum load (150 kg). Run the lift up and down 2 - 3 times and turn the suspension 360° around 2 - 3 times with
maximum load. Perform a new visual control; damage, play and deformations as described above. Any damaged
parts must be repaired or replaced and the test is performed once more until the lift performs correctly.
Checked that the leg spreading mechanism functions properly. Tested with maximum load. Verifi ed that the legs do
not move beyond inner and outer limits (working position) when operated with load. The legs does not move inside
parallel positions (or working position) with column mounted.
Checked that emergency stop and lowering (electric and manual) are working correctly.
Service light is green and batteries are suffi ciently charged.
Marked lift with safety sticker with month/year and certifi cate number for completed safety inspection. Inspecting
person must sign safety sticker and this diagram.
Inspection, repair and service should be done by a person certifi ed by, or on behalf of Molift Group AS.
Always complete below:
Client:________________________________ Serial number of lifter:_______________________________
Date: ________________________________ Signature:_________________________________________
