RHT-4754 Hand Crimp Tool
Doc No. 64003-7200
Release Date: 08-02-06
UNCONTROLLED
COPY
Page 5 of 7
Revision: A
Revision Date: 08-02-06
“ X ”
NOT POSSIBLE TO PIN GAUGE,
MEASURE A
CRIMPED UNINSULATED TERMINAL OR
SLUG*
*SOLDER, LEAD OR
SIMILAR SOFT
METAL
Tool Calibration
A Certificate of Calibration (See Last Page) was supplied with the tool. To recalibrate this
Tool, a soft metal slug or solder should be crimped in the conductor nest and the “
X
”
Dimension measured in each conductor nest and compared to this chart. The tool should be
lubricated prior to recalibration to ensure consistent measurements. Handle preload is
factory set to 25-45 LBS. See How to Adjust Tool Preload (See Figure 7) to recalibrate.
Nest Color Code
Wire Range
“X” Dimension
Conductor Crimp
Awg
mm²
Mean
Go
No Go
Red
22 - 18 0.35 - 0.80
.052
.049
.060
Blue
16 - 14 1.30 - 2.00
.061
.058
.069
CAUTION:
Repetitive use of this tool should be avoided.
Warranty
This tool is for electrical terminal crimping purposes only. This tool is made of the best quality
materials. All vital components are long-life tested. All tools are warranted to be free of
manufacturing defects for a period of 30 days. Should such a defect occur, we will repair or
exchange the tool free of charge. This repair or exchange will not be applicable to altered,
misused or damaged tools. This tool is designed for hand use only. Any clamping, fixturing,
or use of handle extensions voids this warranty.
Hand held crimping tools are intended for low volume, prototyping, or repair requirements
only.
CAUTION
: Molex crimp specifications are valid only when used with Molex terminals,
applicators and tooling.
