HT60923A Extractor Tool
Doc No: ATS-011030043
Release Date: 02-02-95
UNCONTROLLED COPY
Page 4 of 5
Revision: J
Revision Date: 02-23-09
TERMINAL
PUSHED IN
LOCKING TANG
PUSHED DOWN
EXTRACTOR
TOOL ON AN ANGLE
HOUSING
50148-8*00 TERMINAL
ROTATE THE
EXTRACTOR
TOOL UP
FIGURE 6
LOCKING TAB
OF HOUSING
WIRE
Figure 7
EXTRACTOR
TOOL
LOCKING TAB
PUSHED UP
TERMINAL
HOUSING
EXTRACTOR
TOOL
5.
Insert the tip of the Extractor Tool on an angle above the terminal into the slot on the bottom of the connector
housing.
6.
While rotating the extraction tool up, bend the terminal locking tang down and push the terminal back through
the connector slot. Make sure that the terminated wire is pulled out at the same time. See Figure 6.
For 50420 Terminal Series:
1.
Push the terminal forward in the arrow direction before using the Extractor Tool.
2.
Insert the tip of the Extractor Tool on an angle above the terminal into the slot on the top of the connector
housing.
3.
While rotating the extraction tool down, bend the terminal locking tang down and push the terminal back
through the connector slot. Make sure that the terminated wire is pulled out at the same time. See Figure 7.
