Tool Kit for P-Lock Flag Female Terminal
Doc No: ATS-6382567HM Release Date: 03-19-13
UNCONTROLLED COPY
Page 4 of 8
Revision: A
Revision Date: 03-19-13
For the Battery Power Tool:
1.
Cycle the Battery Power Tool to crimp the terminal to the wire.
2.
Remove the crimped terminal from the terminal locator by pressing down on the wire stop and gently pulling on
the wire. The terminal locator can be in either position.
3.
Visually inspect the crimped terminal for proper crimp location.
Maintenance
It is recommended that each operator of the tool be made aware of, and responsible for, the following maintenance
steps:
1.
Remove dust, moisture and other contaminants with a clean brush, or soft, lint-free cloth.
2.
Do not use any abrasive materials that could damage the tool.
3.
Make certain all pins; pivot points and
bearing surfaces in the tool head are
protected with a thin coat of high quality
machine oil. Do not oil excessively. This
tool was engineered for durability, but like
any fine piece of equipment, it needs
cleaning and lubrication for a maximum
service life of trouble-free crimping. The
use of light oil, such as 30 weight
automotive oil, every 5,000 crimps or
monthly, will significantly enhance the tool
life and ensure a stable calibration. See
Figure 5A or 5B for lubrication points.
4.
Store the tool in a clean and dry area when
not in use.
Miscrimps or Jams for Crimp Hand Tools Only
(See Figure 8)
Should this tool ever become stuck or jammed in a partially closed position,
Do Not
force the handles open or
closed.
The tool will open easily by rotating the small slotted screw marked with an arrow. See Figure 8.
Warranty
This tool kit is for electrical terminal crimping purposes only. This tool kit is made of the best quality materials. All
vital components are long life tested. All tools are warranted to be free of manufacturing defects for a period of 30
days. Should such a defect occur, we will repair or exchange the tool kit free of charge. This repair or exchange
will not be applicable to altered, misused, or damaged tools.
CAUTION
: Molex crimp specifications are valid only when used with Molex terminals and tooling.
LUBRICATION
POINTS
(BOTH SIDES)
LIGHT OIL
(EVERY MONTH
OR
5,000 CRIMPS)
Figure 5A
Figure 5B
