Tool Kit for MP-Lock™ Female Terminal
Doc No: ATS-6382548HM Release Date: 07-23-12
UNCONTROLLED COPY
Page 3 of 8
Revision: A
Revision Date: 07-23-12
SWING
LOCATOR
OPEN
PRESS DOWN
ON THE BRASS
PIVOT SHAFT
LIFT UP ON
THE LOCATOR
Figure 2
ANVILS
POWER
CRIMP
HEAD
Figure 1
PUNCHES
M4 X 10 LONG
BHCS
M4 X 18 LONG
BHCS
SWING OPEN
TERMINAL
PUSH HERE TO
OPEN WIRE STOP
LOCATOR
TERMINAL
IN PLACE
Figure 4
LOCATOR LATCH
IN OPEN POSITION
To install the locator
1.
Position the locator with the hole over the brass pivot shaft and snap it into place.
To remove the locator
1.
Open the crimp hand tool.
2.
Swing the existing locator open and away from the hand tool.
3.
Firmly press down on the brass pivot shaft with your thumb, while pulling the locator up. Slip the locator off the
top of the brass pivot shaft.
OPERATION
Open the tool by squeezing the handles together, at the
end of the closing stroke, the ratchet mechanism will
release the handles, and the hand tool will spring open.
Crimping Terminals
1.
Select the desired terminal listed in the preceding
charts.
2.
Turn the Locator Lock Latch down to unlock. See
Figure 3.
Figure 3
LATCH LOCKED
LATCH UNLOCKED
