Tool Kit for 250 MP-Lock Terminal
Doc No: ATS-6382355HM Release Date: 03-09-11
UNCONTROLLED COPY
Page 4 of 9
Revision: A
Revision Date: 03-09-11
SWING OPEN
TERMINAL
PUSH HERE TO
OPEN WIRE STOP
LOCATOR
TERMINAL
IN PLACE
Figure 4
LOCATOR LATCH
IN OPEN POSITION
Figure 6
WIRE IN TERMINAL
JAWS
PARTIALLY
CLOSED
WIRE AGAINST
WIRE STOP
HANDLE
OPEN
LOCATOR
CLOSED
Figure 5
TERMINAL
PUSH HERE TO
OPEN WIRE STOP
7.
Insert the proper wire over the terminal.
8.
Gently touch the wire stop with the end of the wire. See Figure 6 and 7.
9.
Compress the terminal by squeezing the tool handles until the ratchet mechanism cycle has been completed.
Release handles to open the jaws.
10.
Remove the crimped terminal from the terminal locator by pressing down on the wire stop and gently pulling on
the wire. The terminal locator can be in either position.
11.
Visually inspect the crimped terminal for proper crimp location.
Note
: The tamper proof ratchet action will not release the tool until it has been fully closed.
For the Battery Power Tool:
1.
Cycle the Battery Power Tool to crimp the terminal to the wire.
2.
Remove the crimped terminal from the terminal locator by pressing down on the wire stop and gently pulling on
the wire. The terminal locator can be in either position.
3.
Visually inspect the crimped terminal for proper crimp location.
