GenePix SL50 Slide Loader User Guide
5001410 B
25
2.
Using the handle on top of the slide cassette, lift the left slide
cassette out and place it on a stable position on the counter.
Figure 2-3
Slide enclosure door open with both slide cassettes
visible
3.
With each slide held between your thumb and finger, carefully
place slides, feature-side down and barcode facing the front,
into empty slots in the slide cassette.
4.
When you have placed all slides for scanning into the slide
cassette, return the cassette to the slide enclosure by inserting
it at a slight angle tilted away from you, then straighten it until it
fits securely in the slide enclosure. You will hear a click when it
is in place.
5.
If additional slots are required, perform
with the right slide cassette.
CAUTION!
Do not access the slides in the cassette through the belt
opening.
Note:
The motion arm uses a sensor to locate and map slides in
the cassette slots before beginning the batch scan.
GenePix SL50.book Page 25 Tuesday, February 1, 2011 12:20 PM
