A supplemental oxygen gas tank is required to operate
the Lotus nanobubble generator. Oxygen gas tank is not
included. For safety, follow local electrical codes.
Notes
Unpacking
Installation
Attach Oxygen Tank
Scan to Download the Owner’s Manual
and access warranty information for the
Lotus Nanobubble Generator.
www.moleaer.com
Ensure all accessories were provided
with your Lotus. Contact Moleaer
for replacement parts. Inspect outer
surfaces for shipping damage.
Open lid and remove packaging and
accessories from the inside.
Inspect components inside of
unit for any loose tubing or damaged
components and tighten any
loose fittings or tubing.
NANOBUBBLE GENERATOR
Quick Start Guide
1.1
1.2
1
2
3
I
nstall unit on a level surface.
Position unit within three feet of a standard
three-prong 120-volt outlet (15-amps).
Position unit as close to the water tank as
possible, while maintaining a minimum
distance to electrical outlet.
Ensure there is a minimum one-foot
clearance on all sides of unit to avoid risk
of damage.
Ensure the pump level is below the
minimum water level in the tank so the
pump is fed by gravity. Please see the
detailed operating manual for non-flooded
suction installations.
Unit Position
& Location:
2.1
2.2
2.3
2.4
2.5
Rent or buy a K or T style
oxygen gas tank.
Connect the regulator
A
to
the O
2
tank, set the dial to 0.
Connect the air fitting
D
to
the Lotus enclosure.
Connect the gas tube between
the regulator and the air fitting.
Use the snap-grip clamps for
securing the tube.
Turn the regulator knob to the
lowest settings and check for
leaks using soapy water. Turn
the regulator dial back to 0.
3.1
3.2
3.3
3.4
3.5
+1.424.558.3567
O
2
tank, water tank and pipes not included.
A
Gas Regulator,
B
Piping Connections,
C
Spare O-rings
D
Barbed Fitting,
E
Tube,
F
Snap-Grip Clamps,
G
CIP Kit,
H
Keys
1.3
A
B
C
D
E
F
H
G
