11.4 Unpacking
WARNING
When doing any work that requires lifting the machine, connect all lifting
devices and support the machine using a crane of adequate capacity
before commencing work. Failure to support the machine can result in
severe injury or death. See “E-Multi Weight Specifications” on page 3-20
for weight, dimensions and safe lifting instructions.
The crate should be moved using a forklift or pallet truck. If using a crane,
the crate must be slung from underneath. Never lift from the top of the
crate.
1. Remove the lid and the plastic wrap as necessary.
2. Inspect the unit prior to removing any of the crate walls or bracing. See
“11.5 Inspection” on page 11-4.
3. Attach the slings to the unit as shown in Figure 11-2, Figure 11-3 and
Figure 11-4. Use the slings provided in the crate. Note the approximate
point of the center of gravity.
4. Raise the lifting machine just enough to reduce the slack in the slings.
Ensure that the lifting point is positioned above the center of gravity and
the unit will not swing when lifted.
5.
Remove the remaining crate sides and bracing, leaving the crate floor and
all floor bracing around the adapter plate.
6. Remove the accessory boxes and anything other than the E-Multi Radial.
3
1
2
1. Forward sling (barrel end) - 6 ft
2. Rear sling (motor end) - 4 ft
3. Approximate center of gravity
Figure 11-2 Sling positions of the E-Multi Radial vertical beam
(in horizontal orientation) and the approximate location of the center of gravity.
11-3
E-MULTI RADIAL OPTION
E-Multi User Manual
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.