MoJack EZ Lift
MoJack EZ Lift
16
17
Operating Instructions
STEP 19
STEP 20
Raising the MoJack EZ with a power drill
(optional)
• The MoJack EZ can be raised or lowered by using a
variable speed corded drill (7 amp minimum) or variable
speed cordless drill (18V minimum).
• The drill will require a 3/8” square driver (not provided).
• Remove Crank Handle by taking out the nut and bolt
which reveals the 3/8” Square Receiver.
• Firmly insert the 3/8” driver in the Square Receiver.
Rotate the drill forward (clockwise) to raise
the Lift Arm and rotate the drill in reverse
(counterclockwise) to lower the Lift Arm.
• Carrier Locking Pin must be pulled out when
lowering until it clears the bottom Safety Hole.
• Follow all other operating instructions while using the
drill attachment.
• Replace the Crank Handle for future use.
Operator must have a firm grip on the drill before
raising or lowering the Lift Arm.
THE MOJACK EZ IS NOW READY FOR STORAGE OR TRANSPORT.
Folding the MoJack EZ
• Pull and rotate Tower Locking Pin 90 degrees to the unlocked position.
• Raise the Tower out of the Base by pulling up on the Lift Handle and
then lower the Tower.
• Secure the Tower by rotating Tower Locking Pin until the ring drops
into locking slot.
Tower
Locking
Pin
3/8”
Square
Driver
Square
Receiver
Screw
Thread
Maintenance Schedule
• Before each use, always check for any worn, loose or
damaged parts on the MoJack EZ. If any damaged parts
are present, do not use the MoJack EZ and contact
MoJack at 1-877-575-3173.
• Clean and oil the screw thread after every 50 uses or at
least once a year using light machine oil.
• Place lithium grease between the Crank Handle Base and
the brass bearing after every 50 uses or once a year.
Without weight on carrier, lift the Crank Handle to create
a small gap between the brass bearing and the Crank
Handle Base. Use a small brush to apply the lithium
grease between the two surfaces.
• Place lithium grease on or around Screw Thread Bottom,
Roll Pin and Screw Thread Bottom Washer after every 50
uses or at least once a year.
• Spray grease or lube in Locking Pin holes and shaft after
every 50 uses or at least once a year.
• (Optional) Check for Carrier Locking Pin operation. Turn
top Crank Handle to raise the Lift Arm to the first Safety
Hole and listen for click as pin pops into hole. After a
click is heard, reverse direction of Crank Handle rotation
without pulling on the Carrier Locking Pin ring. Pin
should hold Carriage at height. Do not force the handle
past the lock point, as this may damage the Screw
Thread. If Carrier Locking Pin does not hold Lift Arm
height, do not use the MoJack EZ and contact MoJack at
1-877-575-3173. After checking Carrier Locking Pin
operation, proceed to lower by pulling out on the Carrier
Locking Pin ring.
Safety Hole
Carrier
Locking
Pin
Pull Out
to Lower
Screw Thread
Brass Bearing
Crank Handle Base
Screw Thread Bottom
Screw Thread
Bottom Washer
Roll
Pin
Tower Locking Pin
Содержание EZ
Страница 1: ...Ver 093011 ...
