1.0 Introduction
The AE100M series is a weatherproof electronic sounder designed for use in harsh
environmental conditions and is manufactured from UV Stable Polycarbonate
plastic. The sounder has a 3 stage alarm option & has 60 tone options that can be
pre-selected. A stainless steel mounting bracket allows the unit to be pivoted through
180 degrees to maximise directional audibility.
2.0 Voltage Classifications
The AE100M is available for the following voltage ranges:
AE100M-02 – 12-48v DC or AE100M-04 – 100-240V AC
3.0 Installation
General Requirements
•
Installation must be carried out in accordance with the latest codes and regulations
by a qualified electrician.
•
Ensure power is disconnected prior to installation or maintenance.
•
Environmental exposure conditions during installation should be dry, not moist
or wet.
•
Avoid mounting the sounder where it will be subject to excessive vibration.
Location
The location of the unit should be made with due regard to the area over which the
sounder warning signal must be audible. The unit should only be fixed to services
that can carry the weight of the unit.
Mounting
The unit mounts via a ‘U’ shaped stainless steel bracket by using one 8mm
dia and two 6mm dia bolt holes in the centre of the bracket (see picture 1). The
alignment and positions can be adjusted by loosening the two M6 screws, which
fasten the stainless steel bracket to the sounder. The sounder should be positioned
such that dust, debris or water cannot enter into the horn opening.
4.0 Wiring
General Requirement
Moflash recommends that all cables and cores should be fully identified (suggest
using cable from 2.0 to 2.5 mm²). Ensure that all nuts, bolts and screws are secured.
Ensure that only the right and certified cable glands are used and earthed correctly.
Ensure that only the right and certified stopping plugs are used to blank off unused
gland entry points. In order to maintain the IP rating of the product, we recommend
SS316L for this application.
Cable Connection
The cable connection is to terminals on the
PCB located within the enclosure of the
sounder. Cable connection should be carried
out in accordance with relevant technical
requirements (see picture 1)
For AC supply - connect to terminals marked ‘L’ & ‘N’.
For DC supply - connect ‘+’ to ‘L’ and ‘-‘ (0v) to ‘N’.
Alarm stages - terminals ‘S0’ (common) ‘S1 & S2’
(refer to table overleaf). With ‘D’ or ‘Dly’ as the delay function.
Do not connect AC or DC to S0, S1, S2 or D.
Removal of End Cover
Unscrew the four (4) M5 retained hex socket head screw (see diagram 2). Twist
the cover gently clockwise and anti-clockwise, whilst pulling away from the body,
keeping the cover parallel to the body until it comes free. This will allow the cover to
hang on its retaining strap. Before replacing the cover, check the joints are clean and
not damaged, the gasket is retained in its groove.
4 - M5
SOCKET
SCREWS
Picture 1
Diagram 2
Diagram 1
