
-6-
Revision 5/F3528
LOCATION
This oven must be installed in an area of
adequate air supply. The following minimum
clearances for air openings, servicing,
operation and installation are to be adhered to:
Rear
75mm / 3”
Left-hand side
75mm / 3”
Right-hand side
75mm / 3”
Top
200mm / 8”
(or 600mm from a
combustible
surface.)
Floor
127mm / 5”
OVEN INTERNAL DIMENSIONS
Width
468 mm / 18.5”
Height
533 mm / 21”
Depth
711 mm / 28”
Oven Volume 0.18 m³ / 6.3 ft³
OVEN RACK SIZE
Width
460 mm / 18”
Depth:
660 mm / 26”
GAS SUPPLY SPECIFICATION OPTIONS
Natural
LPG/Prop
(G20
UK)
(G31
UK)
Input Rating
35 MJ/hr
35 MJ/Hr
33 000 Btu/hr 33 000 Btu/hr
9.5
kW
9.5
kW
Gas Rate
0.91 m³/hr
0.67 kg/hr
32.1 ft³/hr
1.48 lb/hr
Supply
1.13 kPa
2.75 kPa
Pressure 4.5”w.c.
11.0”w.c.
(Not USA/Can/UK)
Operating
0.90 kPa
2.25 kPa
Pressure 3.6”w.c.
9.0”w.c.
(Not USA/Can/UK)
Operating
10 mbar
35 mbar
Pressure
(UK only)
Operating
1.13 kPa
2.75 kPa
Pressure 4.5”w.c.
11.0”w.c.
(USA/Can only)
GAS CONNECTION SPECIFICATIONS
½” BSP female - Not USA / Canada
½” NPT female - USA / Canada only
ELECTRICAL SUPPLY SPECIFICATION
OPTIONS
110-120 V AC, 60 Hz, 2.0 A, 1 Phase
220-240 V AC, 50 Hz, 0.7 A, 1 Phase
230-240 V AC, 50 Hz, 0.55A, 1 Phase
220-240 V AC, 60 Hz, 0.7 A, 1 Phase
ELECTRICAL PLUG SPECIFICATION
REQUIREMENTS
Australia
AS 2124, 10 Amp, 3 pin
Canada
NEMA 5-15, 15 Amp, 3 pin
New Zealand
AS 2124, 10 Amp, 3 pin
United Kingdom BS 1363A 13A fused, 3 pin
United States
NEMA 5-15, 15 Amp, 3 pin
Other Countries Type to meet country
standards
BURNER INJECTOR ORIFICE SIZE
LPG/Prop/Butane 1.70
mm / No 51 drill size
Propane (G31)
1.55 mm (UK only)
Natural
2.70 mm / No 36 drill size
Natural (G20)
2.60 mm (UK only)
WATER SUPPLY CONNECTION
Max Pressure 550 kPa / 5.5 bar / 80 psi
Min Pressure 100 kPa / 1.0 bar / 15 psi
AUTOMATIC IGNITION CONTROL
110 Volt Models (24 Volt ignition system)
2 re-ignition attempts after burner ignition
failure. 30 second purge time between
ignition attempts. Lock-out condition after 3
ignition failures.
2 re-ignition attempts in the event of flame
loss during burner operation. 30 second
purge time between ignition attempts. Lock-
out condition after 2 re-ignition attempt
failures.
220-240 Volt Models*
Lock-out condition after burner ignition failure.
No re-ignition attempt.
1 re-ignition attempt in the event of flame loss
during burner operation. Lock-out condition if
re-ignition failure.
*
Specifications apply to units from serial
number 203927.
NOTE:
Refer to Appendix B for further
ignition control specifications.