Moffat Blue Seal Evolution E512 Series, Инструкция по установке и эксплуатации, Страница: 17 / 26

1
Clean the Cooktop regularly. A clean appliance looks better, will last longer and will perform better.
Carbonised grease on the surface or on the griddle plate (If fitted) will hinder the transfer of heat
from the cooking surface to the food. This will result in loss of cooking efficiency.
NOTE: Each griddle option can be supplied with a scraper tool and a pack of blades for cleaning
the griddle surface. These are not supplied with the griddle and have to be purchased
separately. Refer to the ’ Replacement Parts List ’ at the rear of this manual for details.
DO NOT use water on the griddle plate while this item is still hot as warping and
cracking may occur. Allow the griddle plate to cool down before cleaning.
NOTE:

DO NOT use abrasive detergents, strong solvents or caustic detergents as they could
corrode or damage the range.

In order to prevent the forming of rust on the griddle plate (Steel Plate), ensure that any
detergent or cleaning material has been completely removed after each cleaning. The
appliance should be switched on briefly to ensure the griddle plate becomes dry. Oil or
grease should be spread over the griddle surface in order to form a thin protective greasy
film.
To keep your Cooktop clean and operating at peak efficiency, follow the procedures shown below:-
1. Clean the Cooktop with a scraper tool to remove any food debris.
2. Always ensure that the scraper tool blades are changed regularly to ensure that the scraper tool
works efficiently and prevents damage to the griddle plate surface.
1. The grease drawer should be checked and emptied frequently to prevent overflow and spillage.
Remove the grease drawer while still warm so that the grease is in a liquid state. Empty any grease
from the drawer and wash thoroughly in the same manner as any cooking utensil.
2. Thoroughly clean the splash back, the interior and exterior surfaces of the range with hot water, a
detergent solution and a soft scrubbing brush.
3. Clean the Control Panel with a damp cloth lightly moistened with a solution of mild detergent and
water. Dry the control panel thoroughly with a dry cloth and polish with a soft dry cloth.
4. Brush the griddle surface (optional - if fitted) with a soft bristled brush. Any carbon deposits should
be removed using the supplied scraper tool followed by wiping with a cloth moistened with a
solution of mild detergent and hot water to prevent accumulation of food deposits.
T
HE BLADES FITTED TO THE SCRAPER TOOL ARE EXTREMELY SHARP AND ARE TO BE USED WITH CARE
.