INS10903A
12
Wash Test after Installation
1. Check that all water pipelines have been installed
correctly and completely, and open the cold water
valve and water supply T-valve.
2. Turn on the tap to remove carbon particles
and air in the filter. The initial water flow is slightly
turbid, which is a normal phenomenon.
3. Flush the water purifier for about 10 minutes until
the water flow becomes clear. Drinking water can
be produced. If there are slight bubbles, the use
will not be affected.
4. During flushing, check the joints of water pipeline
for leaks to ensure the parts are installed in place.
The observation time should be at least 5 minutes.
5. After flushing, turn off the clean water tap and
make sure there is no leak.
Now, the test is complete.
Usage Instructions
Menu Introduction (for UF1130)
Battery power indicator
Reset
Lifetime indicator for the Filter Cartridge Level 1
Lifetime indicator for the Filter Cartridge Level 2
Lifetime indicator for the Filter Cartridge Level 3
Functions Description
•
• Normal Display