2
在钻孔前，请借助电子探测仪确认墙内是否有电源线、
通讯光缆或者水管之类的物件。使用电钻时，请戴上
防护镜，用完设备后关掉电源。
•
小孩、老人及行动不便者应在有人监护的情况下使用
本产品。
•
控制面板位置应防止浸水和溅水。
•
使用电器产品时应遵循基本的预防措施，包括：
a. 存在触电危险，所有线路必须由持证电工连接。
线路必须接地，
毛巾架架体与控制器请使用型号
为60227 IEC 53(RVV)300/500V横截面积0.75
平方毫米的电源线进行连接，控制器供电请使用
横截面积1.5平方毫米的电源线进行连接，必须按
照布线规则配有断开电源（其触点开距提供在过
电压等级Ⅲ条件下全断开）的装置。
b. 存在触电危险，清洁、维修时必须关闭电源。
c. 存在人员受伤或物品损坏的危险，安装前请仔细
阅读安装指南。
d. 安装产品前，请确保预留中国国标三孔插座。
e. 如果电源线损坏，为了避免风险，须由制造商
维修部或类似部门的专业人员更换。
为避免对婴儿造成伤害，器具的安装应使得最低的加
热架距地面至少600mm。
本产品为暗装产品，需将管线埋入墙体，严禁明装，
导致线材裸露。
Before drilling, please use an electronic detector
to confirm whether there are power cords, com-
munication optical cables or water pipes in the
wall. When using an electric drill: please wear
protective goggles; turn off the power after using
the equipment.
To avoid injury to babies, the appliance should be
installed so that the lowest heating rack is at least
600mm from the ground.
This product is a concealed product, and the
pipeline needs to be buried in the wall.
It is forbidden to install in the open, causing the
wire to be exposed.
• Children, the elderly and people with limited
mobility should use this product under the supervi-
sion of someone.
• The location of the power socket should be
protected from water immersion and splashing.
• Basic precautions should be followed when using
electrical products, including:
a. There is a risk of electric shock, all lines must
be connected by a licensed electrician.The line
must be grounded, and use the model number of
towel rack body and controller for 60227 IEC
53(RVV) 300/500V cross-sectional area 0.75 square
mm power cord for connection, and the controller
power uses a power cord with a cross-sectional
area of 1.5 square millimeters for connection. A
device to disconnect power supply must be
equipped per the wiring rules, which is fully
disconnected under overvoltage level III).
警告
：
Warning:
b. There is a risk of electric shock. The power
must be turned off during cleaning and mainte-
nance.
c. There is a risk of personal injury or damage to
items, please read the installation instructions
carefully before installation.
d. Before installing the product, reserve the
Chinese national standard three-hole socket.
e. If the power cord is damaged, to avoid risks, it
must be replaced by professionals from the manu-
facturer's maintenance department or similar
departments.