Customer Service 908-368-1025
︱
www.modwayfurniture.com
Page 3 of 4
EEI -1181
STASIS OFFICE DESK
In order to properly attach the
Drawer Box (2)
to the side of the
Right Leg (3),
take out the extra space before leg. It will be
necessary to remove the two drawers from the
Drawer Box (2).
Please follow the following steps for drawer removal.
A, Open the drawer fully.
B, Locate the black quick disconnect levers on the right and left-hand slides.
C, Simultaneously press the quick disconnect levers while pulling out the drawer. As shown, the right-hand level is pressed
down, while the left-hand lever releases by pulling up.
STEP 3:
Bx2
Cx2
Fx4
Hx1
Hardware & Tool required
STEP 4:
Carefully turn over the assembled desk.
Attach the
Drawer Box (2)
without drawers to the
Right Leg (3)
by using
Bolts (C)
and
Flat Washers (F)
through the
pre-drilled holes on the inside of the right side panel of the
Drawer Box (2)
and
Right Leg (3).
Do not fully tighten the
Bolts (C)
at this time.
Attach the
Drawer Box (2)
to the
Central Rail (5)
by using
Bolts (B)
and
Flat Washers (F).
Use the
Allen Wrench (H)
to tighten
Bolts (B)
and
Bolts (C)
clockwise until secure
.
Right-Hand Slide:
Press lever down
Left-Hand Slide:
Pull lever up
