3 |
P a g e
TOOLBOXES
Toolboxes are shipped fully assembled.
You will need to remove the drawers before you can install your
toolbox. Open a drawer, hold down the release levers located on the
inside of both slides (see right) and pull the drawer out of the toolbox.
Set the drawers aside and reinsert them after installation is complete.
OVERHEAD CABINETS
Overhead cabinets are shipped fully assembled.
BASE CABINETS
Base cabinets require some assembly. Peel back protective vinyl from contact surfaces as you go.
Assembly Steps:
1. Attach both sides with (7) 10-24 self-tapping screws
[A]
each. To make this easier, you can first
temporarily bolt the sides on with ¼-
/ ” olts
[B]
through the shelf holes.
2. Put the braces in between the sides and fasten each with (4) 10-24 self-tapping screws
[A]
.
DO NOT overtighten self-tapping screws.
Sportsman II cabinets are assembled easily with self-tapping screws.
Start your driver on a low clutch setting and gradually increase it until the screws drive in completely. Overtightening them
will cause the holes to strip, and you'll need to use a #10 nut and bolt instead (not provided). Reset your driver's clutch this
way each time you change batteries.
Drawer release lever
Braces