MODSTER HeliX 150, Руководство пользователя

Страница: 13 / 27

www.modster.at
13
HeliX 150 User Manual
Abnormal Problem Solving Method
7
8
Problem
Connect the battery with
helicopter, then the signal
light keeps flashing and
without response when
operate.
The helicopter without any
response when you
connect the battery.
Push the throttle but the
motor not at work, the
receiver’s signal light keep
flashing
Turn on the helicopter after
bind, the main blade can
rotate but the helicopter
can not take off
The helicopter is violently
shaking
Helicopter spinning to left
after take off.
The helicopter has a little
yaw:
The helicopter has a serious
yaw.
The helicopter without
bind with the transmitter.
Check the power supply
of helicopter and
transmitter;
Check the battery’s
voltage of the helicopter
and transmitter;
Batteries had a poor
connecting.
Helicopter’s battery has a
low voltage;
The lipo battery has a
poor connecting.
Helicopter has a low
voltage;
The main shaft and the
gear may loose.
Main rotor deformed
cross shaft bent
tail rotor bent
Blade clamp screws
are too tight to cause
the main blade can not
rotate
Tail motor has a poor
power;
The blades loose;
Tail motor was broken.
made a operational error
of the trimming button
Bind the transmitter
again
Problem Check the ins-
tallation site of
Transmitter’s batteries;
Use full voltage batteries;
Install the batteries again;
Confirm the batteries
have a good connecting.
Charge the battery or
change a full charge
battery;
Connect the battery with
receiver again.
Charge the battery or
change a full charge
battery;
Press the main shaft and
gear tightly
Change the main blade;
Change the cross shaft;
Change tail rotor;
Loose the blade clamp
screw.
Check the connection
of tail blade and motor
shaft. if loose, change tail
blade or tail motor.
1.According to its yaw
direction, push the trim-
ming button in the
opposite direction;
2.Reset the hovering
point.
Check the servo if work
properly;
Check the swash plate;
Check the rod sticks if
loosing.
Possible Cause Solution